Chosen Solution
Washer does not seem to go into “high” spin cycle and leaves heavy item wet at end of cycle. Tried to extend spin cycle, and tried to re-run entire wash cycle with no improved results.
This can be caused by any one of these: When the clothes are wet at the end of a cycle, check these: Motor coupler Spin cycle Siphoning Water-inlet valve Let us know if it starts happening again for more detail.
The washer was working fine then a pop and rubber burning smell. Now it has the same symptom as above and I only have a towel in the washer and it does not get to a high speed spin. It toggles back and forth to a relative slow spin for a little stops and then changes directions and keeps doing that and then finishes as if all went ok Thanks Stan B
